Restorer not properly diluted or
applied too frequently.
Restorer/maintainer not burnished
soon enough after application
Floor not properly rinsed
before application of finish.
Improper use of disinfectants.
Separation of finish
Alkaline or detergent
contaminated tile.
Finish is applied too
thick.
FINISH SWIRLS OR SCRATCHES
CAUSE
Pad too aggressive
Pad is dirty or has
build-up.
SOLUTION
Under normal conditions,
finishes dry in 30-45 High humidity will extend
these dry times.
Follow label instructions. Overuse
can leave .sticky residue.
When dry, restorer/maintainer will
continue to soften finish if not burnished.
Thoroughly rinse and
neutralize floor after stripping. Use neutral cleaner
in proper dilution.
Measure carefully and follow label
directions.
Finish may have been
exposed to prolonged heat or cold. Shake or stir
before using.
Make sure to rinse floor
until pick-up water remains clear. When recoating,
make sure no cleaner residue remains on floor -
rinse with clean water to prevent problems.
Apply thin coats and
allow each coat to dry before applying the next
coat.
SOLUTION
Use the recommended
pad for a particular task, whether it be burnishing
or cleaning.
Clean with a wire brush
or put pad in deep sink and spray off the build-up.
Hang up to dry.
The
Janitech Companies
106 High Street
Cumberland, RI 02864
(Tel) 401-724-4300, (Fax) 401-724-4900
